EcoSmart ECO 8 Manuel d'instructions télécharger pdf

QUICK INSTALL GUIDE

Models: Eco 8 - 11

This is a quick install reference guide, you must follow the complete installation

instructions and homeowners manual included with the unit.

IMPORTANT SAFETY INFORMATION

As when installing or using any high voltage electrical appliance, basic safety precautions should always be followed.

Under no circumstances should you attempt to clean, install, inspect, repair, disassemble, or otherwise service this water

heater without first shutting off all power to the unit directly at the breaker box. SERIOUS BODILY INJURY OR DEATH

COULD OCCUR IF YOU IGNORE THIS WARNING. THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN AND

PLUMBER IN ACCORDANCE WITH ALL NATIONAL, STATE, PROVINCIAL, AND LOCAL ELECTRICAL AND PLUMBING CODES.

PLEASE READ THESE INSTRUCTIONS THOROUGHLY AND COMPLETELY BEFORE INSTALLATION AND BEFORE USE. FAILURE

TO DO SO COULD CAUSE PROPERTY DAMAGE OR SERIOUS PERSONAL INJURY OR DEATH, AND VOID YOUR WARRANTY.

THIS WATER HEATER MUST BE INSTALLED BY A LICENSED ELECTRICIAN AND PLUMBER PROOF OF INSTALLATION MUST

ACCOMPANY THE WARRANTY CARD.

Plumbing Connection

The Eco 8 -series is supplied with 1/2” NPT and

Eco 11 CF, DO NOT weld or use TEFLON tape or

PASTE. Water heater hoses are strongly

recommended. Connect the COLD water supply

line to the right side of the unit and the

HOT water line to the left side of the unit.

Once both water lines are fastened and secured

you MUST run water through the unit for at least

2 minutes to FLUSH any air pockets (purging) in

the lines, it is recommended that all faucets,

showers etc be run. Failure to follow this step can

cause permanent damage to the unit. This proce-

dure MUST be performed before any electrical

power is turned on.

COLD WATER IN

HOT WATER OUT

Electrical Connection

All units are supplied with (1) sets of wires and a

ground. These wires must be installed to an inde-

pendent double pole breakers as per MODEL specs

below.

Check all wires to make sure they are securely fas-

ten and tight. Before turning the power ON make

sure the system has been flushed as required in the

plumbing section. When the unit is powered up turn

the control knob to turn ON the GREEN LED indicator

light. You can set or adjust your temperature at any

time between 80⁰F - 125⁰F (26⁰ - 51⁰).

Model Required

Breaker

Max Amp

Draw

AWG Cable

Eco 8 1 x 40A DP 37 #08 / 1 set

Eco 11 1 x 60A DP 57 #06 / 1 set

ELECTRICAL SPECIFICATIONS

Installation Question

(877) 474-6473

info@ecosmartus.com

QUICK INSTALL GUIDE 1

Résumé du contenu

Page 1 - QUICK INSTALL GUIDE

QUICK INSTALL GUIDE Models: Eco 8 - 11 This is a quick install reference guide, you must follow the complete installation instructions and homeowners

Commentaires sur ces manuels

Pas de commentaire

EcoSmart ECO 8 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Non EcoSmart ECO 8. EcoSmart ECO 8 Instructions / Assembly Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non EcoSmart ECO 8